Renault Clio: Engine Mounting
- Suspended engine mounting: Tightening torque
- Lower engine tie-bar: Removal - Refitting
- Right-hand suspended engine mounting: Removal - Refitting
- Left-hand suspended engine mounting: Removal - Refitting
READ NEXT:
Suspended engine mounting: Tightening torque
D4F
Tightening torque (in Nm)
K4J, and JH3
K4M, and JH3
K4M, and DP0
K9K, and JR5
K9K, and JH3
K9K, and TL4
D4F, and JH3
M4R, and DP0
F4R
M4R, and TL4
Lower engine tie-bar: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02, Lifting equipment).
Disconnect the battery (see Battery: Remov
Right-hand suspended engine mounting: Removal - Refitting
D4F or K9K, and JH3
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see ) (MR 392, 80A, Battery).
Remove:
the scuttle panel grille (see Scuttle panel grille:
Removal - Refitt
SEE MORE:
Diesel return pipe: Removal - Refitting
K9K, and 764 or 772
IMPORTANT
Consult the safety instructions and cleanliness
advice and the operation recommendations before
carrying out any repairs (see Diesel injection:
Repair precautions).
IMPORTANT
Before carrying out any work on the injection system,
check using the Diagnostic tool :
that
Rear brake calliper: Removal - Refitting
Note:
The callipers supplied as replacement parts are
pre-filled.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
WARNING
Prepare for brake fluid outflow, to prevent damage
to the mechanical parts and bodywork
around the brak
© 2016-2025 Copyright Renault Clio Owners Club
