Renault Clio: General Information
Renault Clio III (2005-2013) Service Manual / Panelwork / General Information
- Specialised bodywork tools: Use
- Structural bodywork documentation: Use
- Vehicle on repair bench: Description
- Structural components to be positioned on the repair bench: Description
READ NEXT:
Specialised bodywork tools: Use
USING THE DASHBOARD CROSS MEMBER
REMOVAL TOOL Car. 1765
Use this tool as indicated in the dashboard removal
procedure.
Fit the tool Car. 1765 as far as the stop (10).
Screw the rod (11) onto
Structural bodywork documentation: Use
B85 or C85
I - CLASSIFYING INFORMATION
This information is classified in two complementary
documents:
1 - Vehicle structure bodywork repair procedures
(MR of the vehicle concerned)
This document compr
Vehicle on repair bench: Description
I - MAIN REFERENCE POINTS BEFORE TRIM-SETTING
1 - Front sub-frame in place
The jig crowns the front sub-frame rear mounting bolt (A).
Use this situation for a rear impact or a light frontal impact
w
SEE MORE:
Front wheel arch: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general informati
Dashboard cross member: Removal - Refitting
Note:
In the event of a front impact with triggering of airbags,
check the area of connection between both
diameters of the beam. If there is any damage visible
to the naked eye, this part must be replaced.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the front doors (see 47A, Side opening
© 2016-2026 Copyright Renault Clio Owners Club - 0.0036
