Renault Clio: Distribution motor: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Air Conditioning / Heating / Distribution motor: Removal - Refitting

LEFT-HAND DRIVE, and CLIMATE CONTROL

REMOVAL

I - REMOVAL PREPARATION OPERATION

Renault Clio. Distribution motor: Removal - Refitting

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Distribution motor: Removal - Refitting

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

Renault Clio. Distribution motor: Removal - Refitting

II - FINAL OPERATION.

RIGHT-HAND DRIVE, and CLIMATE CONTROL

Renault Clio. Distribution motor: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

Renault Clio. Distribution motor: Removal - Refitting

Renault Clio. Distribution motor: Removal - Refitting

Renault Clio. Distribution motor: Removal - Refitting

Renault Clio. Distribution motor: Removal - Refitting

Renault Clio. Distribution motor: Removal - Refitting

Renault Clio. Distribution motor: Removal - Refitting

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Distribution motor: Removal - Refitting

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

Renault Clio. Distribution motor: Removal - Refitting

II - FINAL OPERATION.

Renault Clio. Distribution motor: Removal - Refitting

Note: Check the presence of the rubber filter block on the dashboard cross member reinforcement plate before refitting

Note: Check that the floor carpet reaches under the accelerator pedal end-stop.

READ NEXT:

 Passenger compartment temperature sensor: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Unclip the upper casing. Unclip the lower casing (1). II - OPERATION FOR REMOVAL OF PART CONCERNED Disconnect the passenger compartment temperature

 Air Conditioning

 Air conditioning: Precautions for the repair

AIR CONDITIONING or CLIMATE CONTROL I - SAFETY IMPORTANT The following must be worn when handling refrigerant: gloves, protective goggles (with side shields if possible). In the event of refrigera

SEE MORE:

 Throttle valve: Cleaning

D4F or F4R or K4J or K4M or M4R IMPORTANT Wear leaktight gloves (Nitrile type) for this operation. IMPORTANT Always wear protective gear (gloves, goggles and breathing masks). Note: Be sure to work in a clean environment so as not to allow any contamination of the throttle valve. CLEANING I - CLEAN

 Rear stub axle carrier: Removal - Refitting

DISC BRAKE REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the rear wheel in question (see 35A, Wheels and tyres, Wheel: Removal - Refitting, 35A-1), the rear brake pads (see 33A,

© 2016-2023 Copyright www.rclio.com