Renault Clio: Steering Assembly
- Steering box: Removal - Refitting
- Track rod: Removal - Refitting
- Axial ball joint linkage: Removal - Refitting
- Steering column: List and location of components
- Intermediate shaft: Removal - Refitting
- Steering column adjustment handle: Removal - Refitting
- Steering wheel: Removal - Refitting
READ NEXT:
Steering box: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the front wheels (see 35A, Wheels and tyres,
Track rod: Removal - Refitting
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any repair (see Steering: Precautions for
the repair).
REMOVAL
I - REMOVAL PREPARATION OPERATIO
Axial ball joint linkage: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
Remove the front wheel (see 35A, Wheels and tyres,
Wheel: Removal - Refittin
SEE MORE:
Distribution motor: Removal - Refitting
LEFT-HAND DRIVE, and CLIMATE CONTROL
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the centre console (see Centre console:
Removal - Refitting) (MR 393, 57A, Interior equipment).
Unclip the trim at (1) and (2) at the base of the dashboard.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
D
Sequential gearbox engine speed sensor: Removal - Refitting
D4F, and JA3
REMOVAL
I - REMOVAL PREPARATION OPERATION
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, run command
" Discharge pressure accumulator " AC081.
To confirm the pressure drop, read the " Hydr
© 2016-2025 Copyright Renault Clio Owners Club
