Renault Clio manuals

Renault Clio: Engine Mounting

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Engine Mounting

READ NEXT:

 Suspended engine mounting: Tightening torque

D4F Tightening torque (in Nm) K4J, and JH3 K4M, and JH3 K4M, and DP0 K9K, and JR5 K9K, and JH3 K9K, and TL4 D4F, and JH3 M4R, and DP0 F4R M4R, and TL4

 Lower engine tie-bar: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02, Lifting equipment). Disconnect the battery (see Battery: Remov

 Right-hand suspended engine mounting: Removal - Refitting

D4F or K9K, and JH3 REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see ) (MR 392, 80A, Battery). Remove: the scuttle panel grille (see Scuttle panel grille: Removal - Refitt

SEE MORE:

 Driving advice, Eco-driving

Behaviour Drive carefully for the first few miles until the engine reaches its normal operating temperature, rather than let it warm up while the vehicle is stationary. Speed is expensive. Sporty driving uses a lot of fuel: drive with a light right foot. Do not overrev the engi

 Engine coolant

With the engine switched off and on level ground, the level when cold must be between the MINI and MAXI marks on reservoir 1. Top this level up when cold before it reaches the MINI mark. When working in the engine compartment, ensure that the windscreen wiper stalk is in

© 2016-2025 Copyright Renault Clio Owners Club