Renault Clio: Engine Mounting
- Suspended engine mounting: Tightening torque
- Lower engine tie-bar: Removal - Refitting
- Right-hand suspended engine mounting: Removal - Refitting
- Left-hand suspended engine mounting: Removal - Refitting
READ NEXT:
Suspended engine mounting: Tightening torque
D4F
Tightening torque (in Nm)
K4J, and JH3
K4M, and JH3
K4M, and DP0
K9K, and JR5
K9K, and JH3
K9K, and TL4
D4F, and JH3
M4R, and DP0
F4R
M4R, and TL4
Lower engine tie-bar: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02, Lifting equipment).
Disconnect the battery (see Battery: Remov
Right-hand suspended engine mounting: Removal - Refitting
D4F or K9K, and JH3
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see ) (MR 392, 80A, Battery).
Remove:
the scuttle panel grille (see Scuttle panel grille:
Removal - Refitt
SEE MORE:
Front brake calliper: Repair
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any repair (see Front axle components:
Precautions for the repair).
WARNING
Prepare for the flow of fluid, and protect the surrounding
components.
REPAIR
I - REPAIR PREPARATION OPERATION
Positi
Oil filter: Removal - Refitting
K9K
WARNING
Always check the oil level using the dipstick.
Do not exceed the maximum level on the dipstick
(could destroy the engine).
Correct the engine oil level if necessary before
delivering the vehicle to the customer.
Note:
When topping up the engine oil, always leave at
least 10 minutes be
© 2016-2025 Copyright Renault Clio Owners Club
