Renault Clio manuals

Renault Clio: Cylinder head: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Top And Front Of Engine / Cylinder head: Removal - Refitting

READ NEXT:

 D4F, and 740 or 742 or 764

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Disconnect the battery (see Battery: Removal - Refitt

 K4J or K4M

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Remove: the engine cover, the engine undertray bo

 K9K, and 764 or 772

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Remove: the engine cover, the engine undertray,

SEE MORE:

 Rigid brake pipe: Repair

This procedure applies to copper pipes diameter 4.7 mm. Note: This procedure does not apply to: hybrid pipes (pipe + hose), pipes with diameters 6 mm and 8 mm. REPAIR I - PIPE PREPARATION OPERATION WARNING To avoid causing a breakdown in hydraulic brake circuit, do not squash or bend the rigid

 Warning lights

The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND COUNTRY. Instrument panel A: lights up when the ignition is switched on. The brightness can be adjusted by turning control knob 1. In some cases, the appearance of a warning light is accompanied by a message.

© 2016-2025 Copyright Renault Clio Owners Club