Renault Clio: Petrol Injection
- Petrol injection: List and location of components
- Oxygen sensors: Removal - Refitting
- Crankshaft position sensor: Removal - Refitting
- Petrol injection computer: Removal - Refitting
READ NEXT:
Petrol injection: List and location of components
D4F, and 740 or 742 or 764
Petrol vapour rebreathing solenoid
valve
Air inlet pressure sensor
Motorised throttle valve
Injection computer
(5) Fuel injection computer
(6) Motorised throttle v
Oxygen sensors: Removal - Refitting
D4F, and 740
WARNING
Do not use any product designed to improve electrical
contact in the injection computer connectors
and oxygen sensors and on the oxygen sensor
body. Failure to respect this advic
Crankshaft position sensor: Removal - Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting).
Remove the air filter unit (see 12A, Fuel mixture, Air filter unit:
SEE MORE:
Engine cooling: Parts and consumables for the repair
INGREDIENT
Coolant GLACEOL RX (TYPE D)
Note:
Ready-to-use coolant or antifreeze must be diluted
with distilled water in accordance with the guidelines
marked on the container.
Engine cooling: Precautions for the repair
IMPORTANT
The circuits are designed to be pressurized, so be
careful at high temp
Lower engine tie-bar: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02, Lifting equipment).
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove the engine undertray.
II - OPERATION FOR REMOVAL O
© 2016-2025 Copyright Renault Clio Owners Club
