Renault Clio: Crankshaft position sensor: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Petrol Injection / Crankshaft position sensor: Removal - Refitting

D4F, and 740 or 742 or 764

REMOVAL

I - REMOVAL PREPARATION OPERATION

Renault Clio. Crankshaft position sensor: Removal - Refitting

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Crankshaft position sensor: Removal - Refitting

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

II - FINAL OPERATION.

K4J or K4M

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Crankshaft position sensor: Removal - Refitting

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

II - FINAL OPERATION

F4R

REMOVAL

I - REMOVAL PREPARATION OPERATION

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Crankshaft position sensor: Removal - Refitting

REFITTING

I - REFITTING PREPARATION OPERATION

II - REFITTING OPERATION FOR PART CONCERNED

III - FINAL OPERATION.

D4F, and 784 or 786

REMOVAL

I - REMOVAL PREPARATION OPERATION

Renault Clio. Crankshaft position sensor: Removal - Refitting

Renault Clio. Crankshaft position sensor: Removal - Refitting

Renault Clio. Crankshaft position sensor: Removal - Refitting

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Crankshaft position sensor: Removal - Refitting

REFITTING

I - REFITTING OPERATION FOR PART CONCERNED

II - FINAL OPERATION.

READ NEXT:

 Petrol injection computer: Removal - Refitting

D4F, and 740 or 742 or 764 WARNING Do not use any product designed to improve the electrical contact in the injection computer and oxygen sensor connectors or on the bodies of the oxygen sensors. Fai

 Cooling

 Engine cooling: Parts and consumables for the repair

INGREDIENT Coolant GLACEOL RX (TYPE D) Note: Ready-to-use coolant or antifreeze must be diluted with distilled water in accordance with the guidelines marked on the container. Engine cooling: Precauti

SEE MORE:

 K4M, and JH3 - K4J, and JH3 - K4M, and TL4

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Remove: the battery (see Battery: Removal - Refitting) (80A, Battery), the battery tray (see Battery: Removal - Refitting) (80A, Battery), the

 Fuel pressure: Check

D4F CHECK IMPORTANT During this operation, be sure to: be careful of fuel splashes when disconnecting the union. IMPORTANT Wear goggles with side protectors for this operation. IMPORTANT Wear latex gloves during the operation. WARNING To avoid any corrosion or damage, protect the areas on which

© 2016-2022 Copyright www.rclio.com