Renault Clio manuals

Renault Clio: Petrol Injection

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Petrol Injection

READ NEXT:

 Petrol injection: List and location of components

D4F, and 740 or 742 or 764 Petrol vapour rebreathing solenoid valve Air inlet pressure sensor Motorised throttle valve Injection computer (5) Fuel injection computer (6) Motorised throttle v

 Oxygen sensors: Removal - Refitting

D4F, and 740 WARNING Do not use any product designed to improve electrical contact in the injection computer connectors and oxygen sensors and on the oxygen sensor body. Failure to respect this advic

 Crankshaft position sensor: Removal - Refitting

D4F, and 740 or 742 or 764 REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see Battery: Removal - Refitting). Remove the air filter unit (see 12A, Fuel mixture, Air filter unit:

SEE MORE:

 Front side member, centre section: General description

IMPORTANT Use a repair bench to ensure the positioning of the points and the geometry of the axle assemblies. Note: The information contained in the following describes the general repair procedure for all vehicles having the same design for this part. Before reading the following general informati

 Hydraulic unit - master cylinder brake pipe: Removal - Refitting

LEFT-HAND DRIVE REMOVAL I - REMOVAL PREPARATION OPERATION Put the vehicle on a two-post lift (see Vehicle: Towing and lifting). Disconnect the battery (see Battery: Removal - Refitting). Fit a pedal press on the brake pedal. K4J or K4M or K9K Remove the battery (see Battery: Removal - Refit

© 2016-2025 Copyright Renault Clio Owners Club