Renault Clio manuals

Renault Clio: Engine Mounting

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Engine Mounting

READ NEXT:

 Suspended engine mounting: Tightening torque

D4F Tightening torque (in Nm) K4J, and JH3 K4M, and JH3 K4M, and DP0 K9K, and JR5 K9K, and JH3 K9K, and TL4 D4F, and JH3 M4R, and DP0 F4R M4R, and TL4

 Lower engine tie-bar: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02, Lifting equipment). Disconnect the battery (see Battery: Remov

 Right-hand suspended engine mounting: Removal - Refitting

D4F or K9K, and JH3 REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see ) (MR 392, 80A, Battery). Remove: the scuttle panel grille (see Scuttle panel grille: Removal - Refitt

SEE MORE:

 Towing a vehicle with an automatic gearbox

With the engine switched off, the transmission is no longer lubricated. It is preferable to tow this type of vehicle on a trailer or tow it with the front wheels off the ground. Under exceptional circumstances, you may tow the vehicle with all four wheels on the ground, only going forward,

 Sequential gearbox gear lever: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). II - OPERATION FOR REMOVAL OF PART CONCERNED Remove the gear lever cover (1) using a screwdriver. Disconnect the gear lever lighting connector (2).

© 2016-2025 Copyright Renault Clio Owners Club