Renault Clio: Preheating

READ NEXT:

 Pre-postheating unit: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the battery (see Battery: Removal - Refitting), the battery tray (see Battery tray: Removal - Refitting) (MR 392, 80A, Battery). II

 Heater plugs: Removal - Refitting

K9K, and 764 or 772 REMOVAL I - REMOVAL PREPARATION OPERATION Remove the air filter box inlet air pipe (1). Remove the turbocharger outlet air pipe retaining pins (2). Remove: the turbochar

 Antipollution

SEE MORE:

 Water chamber: Removal - Refitting

D4F, and 740 or 742 or 784 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see ) (MR 392, 80A, Battery). D4F, and 740 or 742 Remove the air filter unit (see 12A, Fuel

 Oil vapour rebreathing circuit: Descriptions

K4J or K4M, and 780 or 800 or 801 Oil vapour rebreathing duct Calibrated port Oil vapour recovery plate located on the rocker cover Oil vapour rebreathing hole Oil vapour rebreathing circuit: Operating diagram K4J, and 780 - K4M, and 800 or 801 A: under low loads, the oil vapours are rebr

© 2016-2025 Copyright Renault Clio Owners Club