Renault Clio: Driveshafts
- Driveshaft: Precautions for the repair
- Relay shaft bearing: Removal - Refitting
- Front driveshaft gaiter, wheel side: Removal - Refitting
- Front right-hand driveshaft gaiter, gearbox side: Removal - Refitting
- Front left-hand driveshaft gaiter, gearbox side: Removal - Refitting
READ NEXT:
Driveshaft: Precautions for the repair
DP0 or JH3 or JR5 or TL4
WARNING
A gearbox oil leak at the driveshaft may destroy it.
WARNING
Always replace seals whenever the driveshaft is
removed.
WARNING
Grease the base of the bearing using BR 2
Relay shaft bearing: Removal - Refitting
M4R, and TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Batte
Front driveshaft gaiter, wheel side: Removal -
Refitting
M4R, and TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the driveshaft on the side concerned (see
29A, Driveshafts, Front right-hand driveshaft:
Removal - Refitting, 29A-9) or (see 29A,
Dr
SEE MORE:
Rear quarter panel window: Removal - Refitting
C85 or K85 or S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
C85 or S85
Remove:
the rear wing panel trim (see Rear panel lining:
Removal - Refitting) (71A, Body internal trim),
the rear roof drip moulding trim (see Side roof rail
rear trim: Removal - Refitting) (71A, Body internal
trim),
Brake circuit: Operating diagram
" X " braking system with load-sensitive
compensator
IMPORTANT
This is a diagram of the general principle, do not
use it as a reference for take-off points or circuit
allocation. When replacing components in a vehicle's
braking circuit, always mark the pipes before
removing them.
" X " braking syst
© 2016-2025 Copyright Renault Clio Owners Club
