Renault Clio manuals

Renault Clio: Engine Mounting

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Engine Mounting

READ NEXT:

 Suspended engine mounting: Tightening torque

D4F Tightening torque (in Nm) K4J, and JH3 K4M, and JH3 K4M, and DP0 K9K, and JR5 K9K, and JH3 K9K, and TL4 D4F, and JH3 M4R, and DP0 F4R M4R, and TL4

 Lower engine tie-bar: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02, Lifting equipment). Disconnect the battery (see Battery: Remov

 Right-hand suspended engine mounting: Removal - Refitting

D4F or K9K, and JH3 REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see ) (MR 392, 80A, Battery). Remove: the scuttle panel grille (see Scuttle panel grille: Removal - Refitt

SEE MORE:

 Interior lighting

Courtesy light Press switch 2 for: permanent lighting; intermittent lighting, which comes on when a door is opened. It only switches off after a time delay and when the doors concerned have been closed correctly; lighting switches off immediately. Map reading lights Press sw

 Braking computer: Removal - Refitting

Note: Removal of the ESP or ABS computer is allowed. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove the entire hydraulic unit (see Hydraulic brake unit: Removal - Refitting). II - OP

© 2016-2025 Copyright Renault Clio Owners Club