Renault Clio: Engine Mounting
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Engine Mounting
- Suspended engine mounting: Tightening torque
- Lower engine tie-bar: Removal - Refitting
- Right-hand suspended engine mounting: Removal - Refitting
- Left-hand suspended engine mounting: Removal - Refitting
READ NEXT:
Suspended engine mounting: Tightening torque
D4F
Tightening torque (in Nm)
K4J, and JH3
K4M, and JH3
K4M, and DP0
K9K, and JR5
K9K, and JH3
K9K, and TL4
D4F, and JH3
M4R, and DP0
F4R
M4R, and TL4
Lower engine tie-bar: Removal - Refitting
K9K
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02, Lifting equipment).
Disconnect the battery (see Battery: Remov
Right-hand suspended engine mounting: Removal - Refitting
D4F or K9K, and JH3
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see ) (MR 392, 80A, Battery).
Remove:
the scuttle panel grille (see Scuttle panel grille:
Removal - Refitt
SEE MORE:
Centre Lower Structure
Centre floor front side cross member: General
description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for
Side Lower Structure
Sill panel: Description
B85 or K85
To replace this part, also order the expanding inserts
corresponding to each of the following cases.
The options for replacing this part are as follows:
partial replacement of the front end section, order the
exterior A-pillar insert (see 40A, General informat
© 2016-2026 Copyright Renault Clio Owners Club - 0.0037
