Renault Clio: Scoop under the scuttle panel grille: Removal - Refitting

Renault Clio III (2005-2013) Service Manual / Mechanisms And Accessories / Exterior Equipment / Scoop under the scuttle panel grille: Removal - Refitting

REMOVAL

I - REMOVAL PREPARATION OPERATION

Renault Clio. Scoop under the scuttle panel grille: Removal - Refitting

II - OPERATION FOR REMOVAL OF PART CONCERNED

Renault Clio. Scoop under the scuttle panel grille: Removal - Refitting

Renault Clio. Scoop under the scuttle panel grille: Removal - Refitting

REFITTING

I - REFITTING PREPARATION OPERATION

WARNING

It is essential to replace the foam strips which seal the scoop under the scuttle panel grille. The foam strips are available from the Parts Department.

II - REFITTING OPERATION FOR PART CONCERNED

Renault Clio. Scoop under the scuttle panel grille: Removal - Refitting

Renault Clio. Scoop under the scuttle panel grille: Removal - Refitting

III - FINAL OPERATION

READ NEXT:

 Door mirror: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Unclip the trim (1). II - OPERATION FOR REMOVAL OF PART CONCERNED Remove: the sealing foam (2), the bolts (3) the door mirror. Disconnect th

 Side decorative strips: Removal - Refitting

Note: Once removed, the side decorative strips cannot be refitted and must be replaced each time. REMOVAL I - REMOVAL PREPARATION OPERATION 1 - Front side door Remove: the front side door trim (se

 Sill panel extension: Removal - Refitting

EQUIPMENT LEVEL EAC or EQUIPMENT LEVEL SPORT REMOVAL OPERATION FOR REMOVAL OF PART CONCERNED Remove the bolts (1). Detach the decorative strip (2). Note: Replace the decorative strip (2) ever

SEE MORE:

 F4R, and Left-hand Drive

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery), the air filter unit (see Air filter unit: Removal - Refit

 Vehicle on repair bench: Description

I - MAIN REFERENCE POINTS BEFORE TRIM-SETTING 1 - Front sub-frame in place The jig crowns the front sub-frame rear mounting bolt (A). Use this situation for a rear impact or a light frontal impact without removal of the mechanical components. 2 - Front mechanical components removed The jig rests

© 2016-2021 Copyright www.rclio.com