Renault Clio: General Information
- Specialised bodywork tools: Use
- Structural bodywork documentation: Use
- Vehicle on repair bench: Description
- Structural components to be positioned on the repair bench: Description
READ NEXT:
Specialised bodywork tools: Use
USING THE DASHBOARD CROSS MEMBER
REMOVAL TOOL Car. 1765
Use this tool as indicated in the dashboard removal
procedure.
Fit the tool Car. 1765 as far as the stop (10).
Screw the rod (11) onto
Structural bodywork documentation: Use
B85 or C85
I - CLASSIFYING INFORMATION
This information is classified in two complementary
documents:
1 - Vehicle structure bodywork repair procedures
(MR of the vehicle concerned)
This document compr
Vehicle on repair bench: Description
I - MAIN REFERENCE POINTS BEFORE TRIM-SETTING
1 - Front sub-frame in place
The jig crowns the front sub-frame rear mounting bolt (A).
Use this situation for a rear impact or a light frontal impact
w
SEE MORE:
Throttle valve: Cleaning
D4F or F4R or K4J or K4M or M4R
IMPORTANT
Wear leaktight gloves (Nitrile type) for this operation.
IMPORTANT
Always wear protective gear (gloves, goggles and
breathing masks).
Note:
Be sure to work in a clean environment so as not to
allow any contamination of the throttle valve.
CLEANING
I - CLEAN
Pump assembly: Removal - Refitting
K9K, and JA5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Note:
When replacing the electric pump assembly,
always replace the control relay.
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, run command
" Disc
© 2016-2025 Copyright Renault Clio Owners Club
