Renault Clio: Audible and visual signals

Horn

Renault Clio. Horn


Press steering wheel boss A.

Headlight flasher

Pull stalk 1 towards you to flash the headlights.

Direction indicators

Move stalk 1 parallel to the steering wheel and in the direction you are going to turn it.

One-touch mode

When driving, it is possible that the steering wheel may not be turned sufficiently to return the stalk automatically to its starting position.

In this case, move the stick 1 to halfway, then release it: the stalk returns to its original point and the indicator light flashes three times

Hazard warning lights


Renault Clio. Hazard warning lights


Press switch 2.

This switch activates all four direction indicators and the side indicator lights simultaneously. It must only be used in an emergency to warn drivers of other vehicles that you have had to stop in an area where stopping is prohibited or unexpected, or that you are obliged to drive under special conditions.

Depending on the vehicle, the hazard warning lights may come on automatically under heavy deceleration.

You can switch them off by pressing switch 2 once.

READ NEXT:

 Headlight adjustment

On vehicles fitted with this function, control A allows you to adjust the height of the beams according to the load. Turn control A downwards to lower the headlights and upwards to raise the

 Windscreen washers and wipers

With the ignition on, move stalk 1 A park. B intermittent wiping. The wipers will pause for several seconds between sweeps. It is possible to change the time between sweeps by turn

 Rear screen wash/wipe

Speed-dependent timed rear screen wiper With the ignition on, turn the end of stalk 1 to align mark 2 with the symbol. Wiping frequency varies with speed. When working in the engin

SEE MORE:

 Particle filter pressure sensor: Removal - Refitting

K9K, and 772 The pressure measurement circuit must only ever be opened at the adapters on the exhaust pipe. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02, Lifting equipment). Disconnect the battery (see Battery: R

 Front side member, centre section: General description

IMPORTANT Use a repair bench to ensure the positioning of the points and the geometry of the axle assemblies. Note: The information contained in the following describes the general repair procedure for all vehicles having the same design for this part. Before reading the following general informati

© 2016-2024 Copyright Renault Clio Owners Club