Renault Clio: Starting - Charging

READ NEXT:

 Charge circuit: Specifications

D4F or F4R or K4J or K4M or K9K or M4R ALTERNATOR SPECIFICATIONS Charge circuit: Function D4F or F4R or K4J or K4M or K9K or M4R OPERATION These vehicles are fitted with a built-in regulator and an i

 Alternator: Removal - Refitting

K4J, and STANDARD HEATING - K4M, and STANDARD HEATING REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). Remove the air inlet

 Starter: Removal - Refitting

D4F, and 740 or 742 or 764 REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove the air filter unit (see 12A, Fuel mi

SEE MORE:

 Underbody heights: Adjustment value

I - MEASURING POINTS Radius under load: (R1) : Distance between the ground and the front wheel shaft (R2) : Distance between the ground and the rear wheel shaft 1 - Front height (W1) (W1) : Height between the ground and the rear cross member bolt head 2 - Rear height (W2) (W2) : Height be

 Solenoid valve assembly pressure sensor: Removal - Refitting

K9K, and JA5 REMOVAL REMOVAL PREPARATION OPERATION IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, run command " Discharge pressure accumulator " AC081. To confirm the pressure drop, read the " Hydrauli

© 2016-2025 Copyright Renault Clio Owners Club