Renault Clio manuals

Renault Clio: Exterior Protection

Renault Clio III (2005-2013) Service Manual / Mechanisms And Accessories / Exterior Protection

READ NEXT:

 Front bumper: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR392, 02, Lifting equipment). Remove: the lower bolts (1). the front pa

 Front bumper: Stripping - Rebuilding

EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or EQUIPMENT LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5, and DOCUMENTATION PHASE 1 STRIPPING I - STRIPPING PREPARATION OPERATION Remove the f

 Rear bumper: Removal - Refitting

EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or EQUIPMENT LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5, and DOCUMENTATION PHASE 1 - EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUI

SEE MORE:

 High pressure pipe: Check

K9K WARNING After any operation, check that there are no diesel fuel leaks Reprime the diesel circuit using the priming pump. Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). Remove the engine protector. Disconnect the inlet air pressure sensor (1) Remove

 Particle filter temperature sensors: Removal - Refitting

K9K, and 772 The particle filter must be removed in order to remove the catalytic converter upstream temperature sensor. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02, Lifting equipment). Disconnect the battery (s

© 2016-2025 Copyright Renault Clio Owners Club