Renault Clio: Interior Equipment
- Dashboard: Removal - Refitting
- Dashboard: Stripping - Rebuilding
- Centre console: Removal - Refitting
- Centre front panel: Removal - Refitting
- Interior rear-view mirror: Removal - Refitting
- Dashboard cover gaiter: Removal - Refitting
READ NEXT:
Dashboard: Removal - Refitting
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair:
(see Airbag and pretensioners: Prec
Dashboard: Stripping - Rebuilding
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair:
(see Airbag and pretensioners: Prec
Centre console: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the trim (1).
Unclip the gear lever trim.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the bolts (2).
Push the seats forward as far
SEE MORE:
Solenoid valves: Removal - Refitting
K9K, and JA5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Note:
Before removing the solenoid valves, always
mark their respective connectors in order not to
mix them up.
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the acc
K4J or K4M, and Right-hand Drive
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove:
the engine cover,
the scuttle panel grille (see S
© 2016-2025 Copyright Renault Clio Owners Club
