Renault Clio: Front Upper Structure
- Front wing: General description
- Front wing lower mounting support: General description
- Front end panel: General description
- Scuttle side panel: General description
- Front wheel arch: General description
- Dashboard cross member: Removal - Refitting
READ NEXT:
Front wing: General description
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general information,
make s
Front wing lower mounting support: General description
WARNING
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general information,
make
Front end panel: General description
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general information,
make s
SEE MORE:
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
IMPORTANT
During this operation, secure the vehicle to the
lift with a strap to prevent it from becoming unbalanced.
For strapping the vehicle (see 02A, Lifting equipment,
Vehi
K9K, and 772
Detach the turbocharger front temperature sensor
wiring harness on the injector rail protector mounting.
Remove:
the injector rail protector mounting bolts (13),
the injector rail protector support.
Disconnect:
the damper valve connector (14) (if equipped),
the camshaft position
© 2016-2025 Copyright Renault Clio Owners Club
