Renault Clio: Exterior Protection

READ NEXT:

 Front bumper: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR392, 02, Lifting equipment). Remove: the lower bolts (1). the front pa

 Front bumper: Stripping - Rebuilding

EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or EQUIPMENT LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5, and DOCUMENTATION PHASE 1 STRIPPING I - STRIPPING PREPARATION OPERATION Remove the f

 Rear bumper: Removal - Refitting

EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or EQUIPMENT LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5, and DOCUMENTATION PHASE 1 - EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUI

SEE MORE:

 Pump assembly: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Note: When replacing the electric pump assembly, always replace the control relay. IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, run command " Disc

 Cooling system: Draining - Refilling

IMPORTANT The circuits are designed to be pressurised, so be careful at high temperatures (risk of serious burns). Do not remove the cap from the expansion bottle while the engine is hot. Take care when carrying out a repair under the bonnet, as the radiator fan(s) may start to operate without wa

© 2016-2025 Copyright Renault Clio Owners Club