Renault Clio: Exterior Protection

READ NEXT:

 Front bumper: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR392, 02, Lifting equipment). Remove: the lower bolts (1). the front pa

 Front bumper: Stripping - Rebuilding

EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or EQUIPMENT LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5, and DOCUMENTATION PHASE 1 STRIPPING I - STRIPPING PREPARATION OPERATION Remove the f

 Rear bumper: Removal - Refitting

EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or EQUIPMENT LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5, and DOCUMENTATION PHASE 1 - EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUI

SEE MORE:

 Electro-hydraulic unit: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Note: When replacing the electric pump assembly, always replace the control relay. IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, run command " Disc

 Plugs: Removal - Refitting

D4F, and 740 - D4F, and 784 or 786 Spark plug electrode gap REMOVAL I - REMOVAL PREPARATION OPERATION D4F, and 784 Remove the turbocharger air outlet pipe bolt (2) from the inlet distributor. Remove the turbocharger air outlet pipe clip (3) from the turbocharger. Note: If the clip (4) is re

© 2016-2025 Copyright Renault Clio Owners Club