Renault Clio: General Information
- Brake circuit: Operating diagram
- Braking circuit: Bleed
- Underbody heights: Adjustment value
- Front axle system: Tightening torque
- Rear axle system: Tightening torque
- Rigid brake pipe: Repair
READ NEXT:
Brake circuit: Operating diagram
" X " braking system with load-sensitive
compensator
IMPORTANT
This is a diagram of the general principle, do not
use it as a reference for take-off points or circuit
allocation. When replacing compo
Braking circuit: Bleed
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair (see 30A, General information, Brake c
Underbody heights: Adjustment value
I - MEASURING POINTS
Radius under load:
(R1) : Distance between the ground and the front
wheel shaft
(R2) : Distance between the ground and the rear
wheel shaft
1 - Front height (W1)
(W1) : H
SEE MORE:
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove:
the air filter box (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, 12A-17),
the intake distributor (see 12A, Fuel mixture, Inlet
distributor:
RENAULT card: battery
Replacing the battery
When the message “KEYCARD
BATTERY LOW” appears on the instrument
panel, replace the RENAULT card
battery, press button 1 pulling on emergency
key 2, then unclip the cover 3
using tab 4.
Remove the battery by pressing on one
side (movement A) and by lifting the
© 2016-2025 Copyright Renault Clio Owners Club
