Renault Clio: General Information
- Brake circuit: Operating diagram
- Braking circuit: Bleed
- Underbody heights: Adjustment value
- Front axle system: Tightening torque
- Rear axle system: Tightening torque
- Rigid brake pipe: Repair
READ NEXT:
Brake circuit: Operating diagram
" X " braking system with load-sensitive
compensator
IMPORTANT
This is a diagram of the general principle, do not
use it as a reference for take-off points or circuit
allocation. When replacing compo
Braking circuit: Bleed
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair (see 30A, General information, Brake c
Underbody heights: Adjustment value
I - MEASURING POINTS
Radius under load:
(R1) : Distance between the ground and the front
wheel shaft
(R2) : Distance between the ground and the rear
wheel shaft
1 - Front height (W1)
(W1) : H
SEE MORE:
Crankshaft position sensor: Removal - Refitting
D4F, and 740 or 742 or 764
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting).
Remove the air filter unit (see 12A, Fuel mixture, Air filter unit:
Removal - Refitting, 12A-17).
Move the cooling hose away from the engine wiring
harness bracket.
Rear wiring: Connector access
I - LOCATION OF CONNECTORS
R 374 connectors (left-hand rear wiring/front wiring
connection).
B85 or K85
R 2 connector (left-hand rear wiring/dashboard wiring
connection).
R 13 connector (left-hand rear wiring/left-hand rear
door wiring connection).
R 324 connector (left-hand rear wiring/
© 2016-2025 Copyright Renault Clio Owners Club
