Renault Clio: Front Upper Structure
- Front wing: General description
- Front wing lower mounting support: General description
- Front end panel: General description
- Scuttle side panel: General description
- Front wheel arch: General description
- Dashboard cross member: Removal - Refitting
READ NEXT:
Front wing: General description
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general information,
make s
Front wing lower mounting support: General description
WARNING
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general information,
make
Front end panel: General description
Note:
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general information,
make s
SEE MORE:
Front right-hand driveshaft gaiter, gearbox side: Removal - Refitting
DP0 or JH3 or JR5 or TL4
Deflector
Propeller shaft
Driveshaft yoke sleeve
Spider
RC gaiter
Tightening clip
Lock ring
Tightening ring
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Di
Thermostat: Removal - Refitting
M4R
Note:
This engine has two thermostats: one thermostat is
located on the cylinder head and the other is on the
cylinder block.
REMOVAL OF THE CYLINDER HEAD
THERMOSTAT
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lift
© 2016-2025 Copyright Renault Clio Owners Club
