Renault Clio: Wheels And Tyres
- Wheel: Removal - Refitting
- Wheel: Balancing
- Tyres: Removal - Refitting
- Tyre pressure: Identification
- Wheel rim: Identification
READ NEXT:
Wheel: Removal - Refitting
EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2
or EQUIPMENT
LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG
The removal - refitting procedure
Wheel: Balancing
I - PREREQUISITES FOR WHEEL BALANCING
Wheel balancing is a measurement operation.
Several conditions must be met to achieve a reliable
result in a single operation.
The wheel balancer must be in
Tyres: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the wheel in question (see 35A, Wheels and ty
SEE MORE:
Interior rear-view mirror: Removal - Refitting
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip:
the upper cover,
the lower cover.
Note:
When removing the rear view mirror, be careful
not to damage the rain sensor nearby.
Disconnect the connectors.
Remove the rear view mirror.
REFITTING
REFITTING OPERATION FOR PART CONCERN
Running in
Petrol version
For the first 600 miles (1,000 km), do
not exceed 78 mph (130 km/h) in the
highest gear, or 3,000 to 3,500 rpm.
You may only expect top performance
from your vehicle after approximately
1,800 miles (3,000 km).
Service intervals: refer to the
Maintenance Document for your v
© 2016-2025 Copyright Renault Clio Owners Club
