Renault Clio: Opening Element Sealing
Renault Clio III (2005-2013) Service Manual / Sealing And Soundproofing / Opening Element Sealing
Door sealing film: Removal - Refitting
REMOVAL
Note: The sealing film can only be used once; it is destroyed when it is removed.
It is essential to replace the film with a new one each time it is removed.
REMOVING THE SEALING FILM
- Remove the door trim( (see Front side door trim: Removal - Refitting) (MR 393, 72A, Side opening elements trim) or( (see Rear side door trim: Removal - Refitting) (MR 393, 72A, Side opening elements trim).
- Unclip the interior handle mounting (if the vehicle is fitted with one) using an unclipping tool.
1 - First procedure
- Strip off the sealing film using a hot air gun set to approximately
100
READ NEXT:
Window Sealing
Front side door glass run channel: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the door trim( (see Front side door trim: Removal
- Refitting) (MR 393, 72A, Side opening
Soundproofing
Bonnet soundproofing: Removal - Refitting
REMOVAL
REMOVAL OPERATION FOR PART CONCERNED
Remove clips (1) using a pair of unclipping pliers.
Remove the bonnet soundproofing.
REFITTING
REFITTING OPE
SEE MORE:
Sequential gearbox engine speed sensor: Removal - Refitting
D4F, and JA3
REMOVAL
I - REMOVAL PREPARATION OPERATION
IMPORTANT
Before any operation on the sequential system,
discharge the accumulator using the Diagnostic
tool.
To discharge the accumulator, run command
" Discharge pressure accumulator " AC081.
To confirm the pressure drop, read the " Hydr
Lateral acceleration and yaw sensor: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove the centre console (see Centre console:
Removal - Refitting) (MR 393, 57A, Interior equipment).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Cut the carpet usi
© 2016-2021 Copyright www.rclio.com