Renault Clio: General Information
Renault Clio III (2005-2013) Service Manual / Chassis / General Information
- Brake circuit: Operating diagram
- Braking circuit: Bleed
- Underbody heights: Adjustment value
- Front axle system: Tightening torque
- Rear axle system: Tightening torque
- Rigid brake pipe: Repair
READ NEXT:
Brake circuit: Operating diagram
" X " braking system with load-sensitive
compensator
IMPORTANT
This is a diagram of the general principle, do not
use it as a reference for take-off points or circuit
allocation. When replacing compo
Braking circuit: Bleed
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair (see 30A, General information, Brake c
Underbody heights: Adjustment value
I - MEASURING POINTS
Radius under load:
(R1) : Distance between the ground and the front
wheel shaft
(R2) : Distance between the ground and the rear
wheel shaft
1 - Front height (W1)
(W1) : H
SEE MORE:
Warning lights
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT
AND COUNTRY.
Instrument panel A: lights up when
the ignition is switched on. The brightness
can be adjusted by turning control
knob 1.
In some cases, the appearance of a
warning light is accompanied by a message.
Displays and indicators
Rev counter 1
(graduations x 1000)
Speedometer 2
(km or miles per hour)
Overspeed buzzer
Depending on the vehicle, a buzzer
sounds for approximately 10 seconds
every 40 seconds, as long as the vehicle
is travelling in excess of 72 mph
(120 km/h).
Driving style indicator 4
Please r
© 2016-2026 Copyright Renault Clio Owners Club - 0.0035
