Renault Clio: General Information
- Brake circuit: Operating diagram
- Braking circuit: Bleed
- Underbody heights: Adjustment value
- Front axle system: Tightening torque
- Rear axle system: Tightening torque
- Rigid brake pipe: Repair
READ NEXT:
Brake circuit: Operating diagram
" X " braking system with load-sensitive
compensator
IMPORTANT
This is a diagram of the general principle, do not
use it as a reference for take-off points or circuit
allocation. When replacing compo
Braking circuit: Bleed
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair (see 30A, General information, Brake c
Underbody heights: Adjustment value
I - MEASURING POINTS
Radius under load:
(R1) : Distance between the ground and the front
wheel shaft
(R2) : Distance between the ground and the rear
wheel shaft
1 - Front height (W1)
(W1) : H
SEE MORE:
Bonnet lock: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the front bumper (see 55A, Exterior protection,
Front bumper: Removal - Refitting, 55A-1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Remove the bonnet catch bolts (1).
Remove the clip (2) using offset adjusting pliers.
Unclip the sheat
Steering column adjustment handle: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see Battery: Removal - Refitting).
Remove:
the mounting clips (1) on the lower trim of the driver's
side dashboard,
the lower trim (2) of the driver's side dashboard.
Remove:
the bolt-cover protective strip,
the i
© 2016-2025 Copyright Renault Clio Owners Club
