Renault Clio: Rear end panel lining: Removal - Refitting

REMOVAL
I - REMOVAL PREPARATION OPERATION
B85 or C85 or S85

- Remove the luggage compartment carpet.
K85

- Remove the luggage compartment raised floor (1).

- Remove the luggage compartment carpet (2).
- Partially remove the luggage compartment seal.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
B85 or C85 or S85

- Remove the clips (3) using a flat-blade screwdriver.

- Remove the towing ring bolts (4).

- Unclip the rear end panel trim.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
- Refit:
- the rear end panel lining,
- the towing rings.
- Torque tighten the towing ring bolts (21 Nm).
B85 or C85 or S85

II - FINAL OPERATION.
B85 or C85 or S85
- Refit the luggage compartment carpet.
K85
- Remove:
- the luggage compartment carpet (2),
- the luggage compartment raised floor (1).
- Refit the luggage compartment seal.
READ NEXT:
S85
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the rear parcel shelf,
the centre rear parcel shelf (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the clips (2).
Remove
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove the front speaker (see Front speakers:
Removal - Refitting) (MR 392, 86A, Radio).
Unclip the door mirror trim piece (1).
II - OPERATION FOR REM
SEE MORE:
A-pillar: General description
C85
WARNING
The information contained in the following
describes the general repair procedure for all vehicles
having the same design for this part.
Before reading the following general information,
make sure that there are no special notes associated
with the vehicle.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Remove:
the engine cover,
the air inlet duct,
the front
© 2016-2025 Copyright Renault Clio Owners Club
