Renault Clio: Timing belt: Removal - Refitting
Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Top And Front Of Engine / Timing belt: Removal -
Refitting
READ NEXT:
D4F
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Battery: Removal
K4M
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
Remove:
the engine undertray bolts,
the engine u
K9K, and 766 or 768
IMPORTANT
Wear protective gloves during the operation.
WARNING
Never rotate the engine anti-clockwise (timing end).
WARNING
Do not run the engine without the accessories belt
so as not to damage the
SEE MORE:
Rear drum bearing: Removal - Refitting
Using a dial gauge connected to the drum, check that
the end float is greater than 0.03 mm.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
Remove:
the rear wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, 35
Side impact sensor: Removal - Refitting
FRONT SIDE AIRBAG or FRONT SIDE + CURTAIN AIRBAG
IMPORTANT
Consult the safety and cleanliness advice and operation
recommendations before carrying out any
repair (see 88C, Air bag and Pretensioners, Airbag
and pretensioners: Precautions for the
repair, 88C-6).
REMOVAL
I - REMOVAL PREPARATION OPERAT
© 2016-2025 Copyright Renault Clio Owners Club
