Renault Clio: Transporting objects in the boot
Always position the objects transported so that the largest surface is against:
- The rear bench seatback for normal loads (example A).
- The front seatbacks with the rear seatbacks folded down, as is the case for maximum loads (example B).
If you have to place objects on the folded seatback, it is necessary that you lower the headrests before folding the seatback so that it can be folded as flat as possible against the seat.
| Always position the heaviest items directly on the floor. Use the lashing points 1 on the boot floor, if these are fitted to the vehicle. The luggage should be loaded in such a way that no items will be thrown forward and strike the occupants if the driver has to brake suddenly. Fasten the rear seat belts, even if the seats are not occupied. |
READ NEXT:
Towing, attachments
Permissible nose weight, maximum
permissible towing weight,
braked and unbraked: refer to
the information on “Weights” in
Section 6.
For fitting and conditions of use,
Luggage net
Luggage net A
On equipped vehicles, this can be used
when transporting animals or luggage,
to separate them from the passenger
section.
It can be positioned:
behind the front seats;
b
SEE MORE:
Fuel temperature sensor: Removal - Refitting
K9K, and 750 or 752 or 766 or 768
IMPORTANT
Use the diagnostic tool before any operation is carried
out on the injection circuit to check:
that the injector rail is not under pressure,
that the fuel temperature is not too high.
It is essential to respect the safety and cleanliness
advice whenev
Front brake calliper: Removal - Refitting
EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2
or EQUIPMENT
LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG
Note:
The callipers supplied as replacement parts are
pre-filled.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on
© 2016-2025 Copyright Renault Clio Owners Club
