Renault Clio: General Information
Renault Clio III (2005-2013) Service Manual / Chassis / General Information
- Brake circuit: Operating diagram
- Braking circuit: Bleed
- Underbody heights: Adjustment value
- Front axle system: Tightening torque
- Rear axle system: Tightening torque
- Rigid brake pipe: Repair
READ NEXT:
Brake circuit: Operating diagram
" X " braking system with load-sensitive
compensator
IMPORTANT
This is a diagram of the general principle, do not
use it as a reference for take-off points or circuit
allocation. When replacing compo
Braking circuit: Bleed
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and operation
recommendations before carrying out any
repair (see 30A, General information, Brake c
Underbody heights: Adjustment value
I - MEASURING POINTS
Radius under load:
(R1) : Distance between the ground and the front
wheel shaft
(R2) : Distance between the ground and the rear
wheel shaft
1 - Front height (W1)
(W1) : H
SEE MORE:
Windscreen pillar trim: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Partially remove the seal (1).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
Unclip the top of the pillar trim at (2).
remove the pillar trim by pulling upwards.
REFITTING
I - REFITTING PREPARATIONS OPERATION
Check the condition of the clips (3
B-pillar upper trim: Removal - Refitting
C85
REMOVAL
REMOVAL PREPARATION OPERATION
Remove:
the complete rear bench seat,
the rear wing panel lining (see 71A, Body internal
trim, Rear panel lining: Removal - Refitting, 71A-32).
Remove:
the bolt (1),
the seat belt.
Unclip the height adjustment device (2).
Rem
© 2016-2026 Copyright Renault Clio Owners Club - 0.0033
