Renault Clio manuals

Renault Clio: Engine Immobiliser

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

 K9K, and 750 or 752

IMPORTANT Wear protective gloves during the operation. WARNING Never rotate the engine anti-clockwise (timing end). WARNING Do not run the engine without the accessories belt, to avoid breaking the crankshaft accessories pulley. Parts always to be replaced Timing belt, Timing belt tensioning

 Automatic gearbox

Selector lever 1 P: park R: reverse N: Neutral D: automatic mode M: manual mode +: upper gear –: lower gear 4: displays the gear engaged in manual mode. Note: Press the button 2 to go from position D or N to R or P. Operation With the selection lever 1 in position P, switch o

© 2016-2025 Copyright Renault Clio Owners Club