Renault Clio manuals

Renault Clio: Engine Immobiliser

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

 Wheel: Balancing

I - PREREQUISITES FOR WHEEL BALANCING Wheel balancing is a measurement operation. Several conditions must be met to achieve a reliable result in a single operation. The wheel balancer must be installed in accordance with the manufacturer's instructions. It is essential to calibrate the bala

 B-pillar trim: Removal - Refitting

B85 REMOVAL I - REMOVAL PREPARATION OPERATION Move the seats fully forward. Partially remove the frame seals (1). Partially unclip the front and rear door sill trims. II - REMOVAL OF PART CONCERNED Unclip the B-pillar lower trim at (2). Remove the B-pillar lower trim. Unclip bolt c

© 2016-2025 Copyright Renault Clio Owners Club