Renault Clio manuals

Renault Clio: Engine Immobiliser

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

 Clutch circuit: Removal - Refitting

JH3 or JR5 Note: Each time an operation is carried out on the hydraulic clutch system, bleed the circuit: between the reservoir and the bleed hole, between the bleed hole and the clutch release bearing. REMOVAL I - REMOVAL PREPARATION OPERATION K4J or K4M Remove the resonator.   Remov

 Front end lower cross member: General description

WARNING The information contained in the following describes the general repair procedure for all vehicles having the same design for this part. Before reading this general information, check that there are no special notes associated with this vehicle. These special notes are specified if necessa

© 2016-2025 Copyright Renault Clio Owners Club