Renault Clio manuals

Renault Clio: Engine Immobiliser

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

 Exhaust gas recirculation mounting: Removal - Refitting

K9K, and 764 or 766 or 768 To remove/refit the exhaust gas recirculation mountings (see 14A, Antipollution, Exhaust gas cooler: Removal - Refitting, 14A-7). K9K, and 750 or 752 REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see Battery: Removal - Refitting) (MR 392, 80A, Batt

 Front half unit: Description

Left-hand side Right-hand side To replace this part, order the heater bulkhead reinforcement (A) and the side member expanding insert (B). There is only one way of replacing this part: complete replacement. IMPORTANT The straightening bench must be used. I - COMPOSITION OF THE SPARE PART Left

© 2016-2025 Copyright Renault Clio Owners Club