Renault Clio: Manual Gearbox
- Manual gearbox: Identification
- Manual gearbox: Removal - Refitting
- Input shaft lip seal: Removal - Refitting
- Differential output seal: Removal - Refitting
- Reverse gear switch: Removal - Refitting
READ NEXT:
Manual gearbox: Identification
JA3 or JA5 or JH3 or JR5
K4J / K4M / K9K / D4F engines are fitted with type JH
and JR manual gearboxes.
A marking (1) on the gearbox casing indicates:
Gearbox type
Gearbox suffix
Production plan
Manual gearbox: Removal - Refitting
JH3 or JR5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
IMPORTANT
During this operation, secure the vehicle to the
lift wi
Input shaft lip seal: Removal - Refitting
JH3 or JR5
Replace the lip seal after opening the gearbox (see
Technical Note 3661A, gearbox JH - JR).
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the gearbox (see 21A, Manual gearb
SEE MORE:
Tyre pressure
Label A
Open the driver’s door to read it.
Tyre pressures should be checked
when the tyres are cold.
If the tyre pressures cannot be checked
when the tyres are cold, increase the
pressures from 0.2 to 0.3 bar (or 3 PSI).
Never deflate a hot tyre.
Vehicle fitted with a tyre pressu
Hydraulic unit without ESP: Removal - Refitting
LEFT-HAND DRIVE
WARNING
Prepare for the flow of fluid, and protect the surrounding
components.
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equipment).
Disconnect the battery (see Battery: Removal - Ref
© 2016-2025 Copyright Renault Clio Owners Club
