Renault Clio: Manual gearbox: Identification

JA3 or JA5 or JH3 or JR5

K4J / K4M / K9K / D4F engines are fitted with type JH and JR manual gearboxes.

A marking (1) on the gearbox casing indicates:

Renault Clio. Manual Gearbox

  1. Gearbox type
  2. Gearbox suffix
  3. Production plant
  4. Production number

K9K, and TL4 - F4R, and 830, and TL4

Renault Clio. Manual gearbox

  1. Identification plate
  2. Engraving

Renault Clio. Manual gearbox

  1. Gearbox type
  2. Gearbox suffix
  3. Production plant
  4. Production number

Manual gearbox oils: Draining - Filling

JH3 or JR5

Capacity (in litres)

DRAINING

JH3

Renault Clio. Manual gearbox

JR5

Renault Clio. Manual gearbox

FILLING

JH3

Renault Clio. Manual gearbox

JR5

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

Manual gearbox: Specifications

JA3 or JA5 or JH3 or JR5

GEAR RATIOS

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

TL4

GEAR RATIOS

Renault Clio. Manual gearbox

Renault Clio. Manual gearbox

READ NEXT:

 Manual gearbox: Removal - Refitting

JH3 or JR5 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). IMPORTANT During this operation, secure the vehicle to the lift wi

 Input shaft lip seal: Removal - Refitting

JH3 or JR5 Replace the lip seal after opening the gearbox (see Technical Note 3661A, gearbox JH - JR). TL4 REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the gearbox (see 21A, Manual gearb

 Differential output seal: Removal - Refitting

JH3 or JR5 REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Batter

SEE MORE:

 Brake circuit: Operating diagram

" X " braking system with load-sensitive compensator IMPORTANT This is a diagram of the general principle, do not use it as a reference for take-off points or circuit allocation. When replacing components in a vehicle's braking circuit, always mark the pipes before removing them. " X " braking syst

 Five-door version

Side lights/brake and direction indicator lights Open the boot lid and remove screws 1. The bulbs are under pressure and can break when replaced. Risk of injury. To release the light unit, start by moving the exterior edge away to a sufficient extent (movement A) t

© 2016-2026 Copyright Renault Clio Owners Club