Renault Clio: Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

 Air filter unit: Removal - Refitting

D4F, and 740 or 742 or 764 REMOVAL I - REMOVAL PREPARATION OPERATION Apply pressure to (1). Pull at (2). Remove the air breather sleeve (3) from the front end panel. Undo the clip (4) mounting the air filter unit to the motorised throttle valve. Disconnect the oil vapour rebreathing hose

 Refrigerant circuit: Draining - Filling

AIR CONDITIONING or CLIMATE CONTROL IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 62A, Air conditioning, Air conditioning: Precautions for the repair, 62A-1). WARNING Consult the device's operating manual to avoid incorrect use

© 2016-2025 Copyright Renault Clio Owners Club