Renault Clio manuals
{MAINCONT}

Renault Clio: Engine Immobiliser

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

  Brake servo non-return valve: Removal - Refitting

LEFT-HAND DRIVE REMOVAL I - REMOVAL PREPARATION OPERATION K4J or K4M or K9K Remove the engine cover. II - OPERATION FOR REMOVAL OF PART CONCERNED Disconnect the non-return valve (1) at the servo. Pull and turn the non-return valve to release it from the rubber sealing washer. K9K Disconn

  K4J or K4M or K9K or M4R, and Left-hand Drive

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the battery (see Battery: Removal - Refitting) (MR 392, 80A, Battery). the air filter box (see Air filter unit: Removal - Refitt

{VIDEOCONT}
© 2016-2026 Copyright Renault Clio Owners Club - 0.0037