Renault Clio: Engine Immobiliser
- Immobiliser system: List and location of components
- Ignition switch: Removal - Refitting
- Transponder ring: Removal - Refitting
- Start button: Removal - Refitting
- Electric steering column lock: Removal - Refitting
- Battery for remote door locking control: Removal - Refitting
- Card reader: Removal - Refitting
READ NEXT:
Immobiliser system: List and location of components
I - LIST OF COMPONENTS
II - LOCATION OF COMPONENTS
VEHICLE WITH KEY
1 - Antenna/Transponder ring
2 - Ignition switch
3 - UCH
4 - Key
VEHICLE WITH CARD
5 - Front starting aerial
6 - Central start
Ignition switch: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, 80A-1).
Unclip trim (1).
Remove:
the plastic rivet (2),
bolt (3).
Transponder ring: Removal - Refitting
VEHICLE WITH KEY
REMOVAL
I - REMOVAL PREPARATION OPERATION
Unclip trim (1).
Remove:
the plasti-rivet (2),
the bolt (3).
Remove the door seal.
Unclip the dashboard side face (4).
SEE MORE:
To the rear seat belts
Force limiter
Above a certain severity of impact, this
mechanism is used to limit the force of
the belt against the body so that it is at
an acceptable level.
Have the entire restraint
system checked following
an accident.
No operation whatsoever
is permitted on
Thermostat: Removal - Refitting
M4R
Note:
This engine has two thermostats: one thermostat is
located on the cylinder head and the other is on the
cylinder block.
REMOVAL OF THE CYLINDER HEAD
THERMOSTAT
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lift
© 2016-2025 Copyright Renault Clio Owners Club
