Renault Clio: Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

 Xenon headlight high voltage unit: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION IMPORTANT To prevent eye injuries, do not look at a xenon bulb when lit (lighting voltage of 20,000 V). Wait until the " computer-power unit " assemblies have cooled before removing them. It is forbidden to switch on a xenon bulb if the bulb is not f

 Heating: List and location of components

LEFT-HAND DRIVE Control panel Cabin filter Rear air distribution duct Recirculation control cable Air distribution cable Air mixing cable Air distribution unit Heater matrix Fan assembly Heating resistor relay Heating resistors: Blower control unit. Front side air distribution duct Fr

© 2016-2025 Copyright Renault Clio Owners Club