Renault Clio: Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

 Rear wing light: Removal - Refitting

B85 or C85 or S85 REMOVAL OPERATION FOR REMOVAL OF PART CONCERNED Open the luggage compartment. Remove the bolts from the rear wing light (1). Remove the rear wing light. Disconnect the connector from the rear light on the wing. Remove the rear light. If replacing the rear light, remove t

 Front anti-roll bar: Removal - Refitting

EQUIPMENT LEVEL E3 LEISURE or EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL EA2 or EQUIPMENT LEVEL EA3 or EQUIPMENT LEVEL EA4 or EQUIPMENT LEVEL EA5 or EQUIPMENT LEVEL EAG Diameter of the anti-roll bar: 20.5 mm. EQUIPMENT LEVEL EAC or EQUIPMENT LEVEL SPORT Diameter of the anti-roll bar: 19.5 mm. REM

© 2016-2025 Copyright Renault Clio Owners Club