Renault Clio manuals

Renault Clio: Engine Immobiliser

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

 D4F, and 740 or 764

IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5). WARNING To prevent damage to the wiring harness when refitting, observe the original routing. REMOVAL I - REMOVAL PR

 Headlight: Removal - Refitting

DISCHARGE LAMPS, and DOCUMENTATION PHASE 1 IMPORTANT To prevent eye injuries: do not look at a xenon bulb when lit (voltage when lit 20000 V), do not light a bulb which has not been fitted into its headlight. IMPORTANT To prevent burns, wait until the " computers - power unit " assemblies are

© 2016-2025 Copyright Renault Clio Owners Club