Renault Clio: Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

 Wipers (replacing blades)

Replacing windscreen wiper blades 1 With the ignition off, lift wiper arm 2; turn blade 1. Lower tab 3, by pressing on either side A. Then push the blade forwards B, to release hook 4. To refit To refit the wiper blade, proceed in reverse order to removal. Make sure that t

 Front right-hand driveshaft gaiter, gearbox side: Removal - Refitting

DP0 or JH3 or JR5 or TL4 Deflector Propeller shaft Driveshaft yoke sleeve Spider RC gaiter Tightening clip Lock ring Tightening ring REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Di

© 2016-2025 Copyright Renault Clio Owners Club