Renault Clio: Manual Gearbox
Renault Clio III (2005-2013) Service Manual / Transmission / Manual Gearbox
- Manual gearbox: Identification
- Manual gearbox: Removal - Refitting
- Input shaft lip seal: Removal - Refitting
- Differential output seal: Removal - Refitting
- Reverse gear switch: Removal - Refitting
READ NEXT:
Manual gearbox: Identification
JA3 or JA5 or JH3 or JR5
K4J / K4M / K9K / D4F engines are fitted with type JH
and JR manual gearboxes.
A marking (1) on the gearbox casing indicates:
Gearbox type
Gearbox suffix
Production plan
Manual gearbox: Removal - Refitting
JH3 or JR5
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle: Towing and
lifting).
IMPORTANT
During this operation, secure the vehicle to the
lift wi
Input shaft lip seal: Removal - Refitting
JH3 or JR5
Replace the lip seal after opening the gearbox (see
Technical Note 3661A, gearbox JH - JR).
TL4
REMOVAL
I - REMOVAL PREPARATION OPERATION
Remove:
the gearbox (see 21A, Manual gearb
SEE MORE:
To refit a wheel
A wheel size larger than 15” cannot
be installed under the vehicle.
To carry out this operation, the cable
must be unwound.
If the cable has been wound back up on
its own, unwind it again as follows:
pull the handle to unwind the cable;
press the button located und
To lock the system
Press nut 3, screwing it on fully until
it locks in place. Several turns will
be necessary. This operation is essential
to ensure that the wheel is
secure;
return handle 4 to its original position;
clip the tool kit;
replace the cover, then lower it and
replace the luggage com
© 2016-2026 Copyright Renault Clio Owners Club - 0.0044
