{MAINCONT}

Renault Clio: Engine Immobiliser

READ NEXT:

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central start

 Ignition switch: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see 80A, Battery, Battery: Removal - Refitting, 80A-1). Unclip trim (1). Remove: the plastic rivet (2), bolt (3).

 Transponder ring: Removal - Refitting

VEHICLE WITH KEY REMOVAL I - REMOVAL PREPARATION OPERATION Unclip trim (1). Remove: the plasti-rivet (2), the bolt (3). Remove the door seal. Unclip the dashboard side face (4).

SEE MORE:

  Tyre pressure

Label A Open the driver’s door to read it. Tyre pressures should be checked when the tyres are cold. If the tyre pressures cannot be checked when the tyres are cold, increase the pressures from 0.2 to 0.3 bar (or 3 PSI). Never deflate a hot tyre. Vehicle fitted with a tyre pressure

  Battery

This is located under cover 1 and does not need to be serviced. Handle the battery with care as it contains sulphuric acid, which must not come into contact with eyes or skin. If it does, wash the affected area with plenty of cold water. If necessary, consult a doctor.

{VIDEOCONT}
© 2016-2026 Copyright Renault Clio Owners Club - 0.0044